|
Vetus Sani-Processor and Grey Water Discharge System |  |
|
 | The Vetus Sani-Processor offers the possibility to use a standard domestic toilet on board your boat Particularly on larger boats, owners often wish to install deluxe sanitary ware of their
preferred style and colour; just like at home. In order to fulfil this requirement, VETUS has
developed the Sani-Processor, with an electric macerator and a pump, so that an ordinary
domestic toilet may be used on board. The Sani-Processor can be easily connected to a
standard toilet, by means of 102 mm diameter hose (with a minimum fall of 50 mm per
metre). When the toilet is flushed, the Sani-Processor will collect the contents, macerate
them and pump the resultant slurry into a holding tank or directly overboard, through a
hose of only 19 mm diameter. The whole process takes between 10 and 30 seconds and
works almost silently. In the unlikely event of a blockage, the unit can be easily cleaned by
removing the inspection lid. The connecting hoses must be odour-tight and we recommend
the use of VETUS sanitary hose, type SAHOSE, described on page 87.
THE VETUS SANI-PROCESSOR OFFERS THE POSSIBILITY TO USE A STANDARD
DOMESTIC TOILET IN ANY STYLE OR COLOUR YOU CHOOSE, ON BOARD YOUR BOAT. |
|
 | 1. Toilet connection, ø 102 mm
2. Protective grille
3. Waste discharge connections: male ø 19 mm o.d. and female ø 25/28/32 mm i.d.
4. Breather connection, ø 19 mm
5. Washbasin / bidet connection, ø 40 mm
6. Washbasin or shower connection, ø 40 mm
7. Cutter knife (macerator)
8. Electric macerator motor
9. Discharge pump
10. Float switch. |
|
Technical Specifications - Available for 12 or 24 Volt DC or 230 Volt/50 Hz or 120 Volt / 60 Hz.
- Macerator diameter: 98 mm
- Nominal power consumption: approx. 370 W (12V), 435 W (24V), 580 W (110V), 400 W (230V).
- Dimensions : 420 x 120 x 360 mm (l x w x h)
- Hose from toilet to Sani-Processor: ø 102 mm, maximum length 4 metres.
- Hose from Sani-Processor to holding tank: ø 19 mm, maximum length 20 metres.
- The holding tank may be maximum 4 metres higher than the Sani-Processor
- Washbasin/bidet connections: ø 40 mm
- Weight : 4.8 kg
- Pump capacity: approx. 50 l/min at 4 m head. |
|
|
|
|
 | Vetus Grey Water Discharge System In many boats it is impossible to achieve a natural fall from the shower tray or washbasin outlet into the waste water tank. In these cases, the Vetus grey water discharge system (GWDS) is the answer. The GWDS consists of a watertight housing with a discharge pump and automatic float switch. The pump produces very low noise. A non-return valve is fitted in the discharge line. The bottom of the GWDS assembly must be at least 6 cm below the shower tray or washbasin outlet. The waste water tank can be located up to 4 metres above the GWDS unit or up to 20 metres away from it. Instead of pumping the waste water into the holding tank, it can of course also be discharged directly overboard. If the system becomes clogged, the housing cover can be easily removed to clear the blockage. |
|
1. Shower or washbasin connection ø 40 mm
2. Float switch
3. Discharge pump
4. Electric motor
5. Washbasin connection, ø 32 or 40 mm
6. Breather
7. Waste water discharge connection: male ø 19 mm o.d
8. Air conditioner connection, ø 12 mm |  |
|
Technical Spec - Available for 12 or 24 Volt DC or 230 Volt/50 Hz. or 120 Volt/60 Hz.
- Nominal power consumption: approx. 340 W (12V), 350 W (24V), 600 W (120V), 250 W (230V).
- Dimensions : 300 x 165 x 145 mm (l x w x h)
- Pump output : Approx. 44 litres/min.
- Outlet discharge to holding tank : ø 19 mm
- Inlet connections from shower or washbasin : ø 32 or 40 mm
- Weight : 3.5 kg
- Maximum permissible water temperature: 35° C. |
|
|
|
 | Vetus Impermeable Sanitory Hoses "No-Smell" Especially recommended for transportation of biological waste, e.g. in combination with (marine) toilet installations. Made of SBR rubber with inlays of woven synthetic fabric and steel spiral. With-stands temperatures of between - 40° C and + 70° C. Available in coils of 20 m |
|
|
|
|
|
|
|
|
|
|
|
All Trademarks acknowledged as the property of their respective owners. Product information, specification and prices as supplied by the Manufacturers and subject to change without prior notification. Images for illustrative purposes only. E. & O.E.
Chandlery World
Bridge House Marina
Nateby Crossing Lane, Nateby, Garstang, Lancashire, PR3 0JJ, UK
tel: +44 (0)1995 603374 ~ fax: +44 (0)1995 601612
Site designed, hosted and managed by Univiz
